Spread the love


Let’s face it, the first buzzer ViFLY released was a bit premature. There had been quite a few revisions in a short amount of time. I wasn’t a big fan of that so I skipped all of them. But it looks like they have finally settled with the V2 so I got hold of their latest buzzer and see what improvements they made.

Check out this shoot out for a whole list of self-powered buzzers.

You can get the ViFly Finder V2 buzzer from:

Here are the spec of the ViFly Finder V2 Buzzer:

  • Size: 24x13x16mm
  • Weight: 4.9g
  • Volume, same as V1, my measurement was 106dB
  • Battery: 80mAh – 30 hours runtime
  • Input Voltage takes 4.5V – 8.5V

In the nice plastic box comes with

  • 3-wire cable
  • Cable tie
  • Manual

Connectors are the same in V1 and V2.

To sum it up, here are the major improvements from V1:

  • Added onboard LED (Very Bright!)
  • Longer battery life
  • Supports PWM signal
  • $2 Cheaper!

The rest of the spec are pretty much the same.

The first big difference is the increase run time. The battery is the same capacity as the V1. They achieved longer run time by changing how frequently the buzzer beeps, from merely 6 hours in the V1, to 30 hours in the V2. I think that’s a much better approach to take.

I suggested VIFLY to add a bright LED when I was reviewing the first version, in order to provide both visual and audio aid, and they did it! They even took it a step further and added a light sensor, so the LED only flashes when it’s dark. This will help tremendously when searching for your model at night. LED won’t light up in day light in order to save battery.

Here are the locations of the components.

Finally, the ViFly Finder V2 is probably the first self-powered buzzer to support PWM signal. It’s perfect for models that don’t use flight controllers, such as RC planes, so you can connect this buzzer directly to the receiver. I am going to use this on the S800 FPV wing I recently built 🙂

There are 3 wires you need to connect: GND, 5V (Buzzer+) and BZ (Buzzer- or PWM).

The Buzzer and LED can be activated by a switch on your transmitter (just like setting up a normal buzzer in Betaflight Modes tab). For PWM signal, 1500-2000 will also activate the buzzer and LED. You might want to setup failsafe to output this level on the channel when signal is lost.

When power is lost it will be activated automatically:

  • First 40 seconds – beeps in low volume (around 96dB)
  • 40 seconds to 2 hours – beeps every 4 seconds at full volume (106dB)
  • beyond 2 hours – beeping frequency reduced to every 10 seconds

The built-in battery gets charged when the buzzer is connected to 5V. So you don’t have to worry about taking it out of the model and charging it separately. However It does take up to 90 minutes to fully charge, so make sure to leave it connected long enough when you first setting it up.

Not only it’s now useful for long range quads, it’s also great for wings and RC planes. You can hook it up to flight controllers, or connect it directly to a PWM channel in the receiver. Great!

However it’s still quite bulky just like the V1. While it’s fine for builds with lots of space, it can be challenging to fit in micro quads. For tiny self-powered buzzers, I’d recommend the Hell Gate (the smallest, expensive but original idea), or the FullSpeed Lucky box (cheap).




Source link